Make sure to use the correct handle position (refer to Table A and Figure 8). With the vehicle in PARK and the engine running, insert tool J-51155 into the pipe. Refer to Table A for the correct position for a given vehicle.
The handle on tool J-51155 has two positions, red and blue (see Figure 6 and 7). Tool CVT Oil Level Quick Check Gauge (J-51155) can now be used to determine the CVT fluid level. Pull to remove the cap from the charging pipe. Remove tool J-52611 from the cap (see Figure 5). Notice the gap between the cap and charge pipe in Figure 4. The cap’s locking tab is unlocked while squeezing. Squeeze the tool toward the cap, and then slightly lift the cap (see Figure 3). NOTE: The tool shown in Figures 3 and 4 is the same as the one shown in Figure 2, but looks slightly different. Install special tool CVT Charge Pipe Cap Release (J-52611) where shown in Figure 3. Shift the transmission into REVERSE for 5 seconds.Ħ. Shift the transmission into DRIVE for 5 seconds.ĥ. Shift the transmission into REVERSE for 5 seconds.Ĥ. Using a scan tool, ensure that the CVT fluid operating temperature is within the range of 170☏-180☏ (77☌-82☌).ģ. Park the vehicle on level ground (engine running, parking brake set).Ģ. Search for J-5261 and then select the Charge Pipe Cap Release Tool.ġ.
A video on how to use tools is available on. Steps 1 through 6 will ensure that CVT fluid is properly distributed throughout the transmission. Also, tools can be obtained from Tech-Mate at 1-80. Special tools CVT Oil Level Quick Check Gauge (J-51155) and CVT Charge Pipe Cap Release (J-52611) are now available from Nissan and dealers, Figure 1 and 2. *APPLIED VEHICLES equipped with CVT ONLY Figure 1.